Similar to the weighing procedure carried out in your school laboratory, place the pan and 'zero' or tare the electronic weight balance. This equipment is ultra sensitive and uses a pan of 3mm in diameter.
Step 2:
Measure and weigh the sample mass
Measure and weigh the sample mass
Step 3:
We proceed to investigate on the physical property.
Encase the sample powder in the Aluminium dish to form a pellet. Press HARD!
We proceed to investigate on the physical property.
Encase the sample powder in the Aluminium dish to form a pellet. Press HARD!
Removing.....
Step 4:
After turning on the nitrogen tank and calibrating the DSC, carefully remove the 3 different lids of the DSC machine!
After turning on the nitrogen tank and calibrating the DSC, carefully remove the 3 different lids of the DSC machine!
Step 5:
After placing the sample, put back the lids!!!
After placing the sample, put back the lids!!!
Step 6: Data is recorded and some characteristics are observed.
Extras: Using charts from TA instruments to observe characteristics and thermal behaviours.
Find out more on the machine:
No comments:
Post a Comment